Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to cross probe the dx designer schematic to PADS Layout VX2.1 ??

Status
Not open for further replies.

kabaleevisu

Advanced Member level 2
Joined
Apr 14, 2010
Messages
616
Helped
85
Reputation
170
Reaction score
81
Trophy points
1,308
Location
Chennai,India
Activity points
4,512
Hi Everyone,

i am currently working for Dx-designer to PADS Layout flow.In General, if i want to find the UX ? in schematic which will highlight or show that footprint in Layout.That cross reference or cross probing i could see in Cadence allegro tool to sync up the orcad and PCB Editor tool. but i could not see that option in Dx-Designer to PADS Flow.can any please help for this post. (i could see that option in available in PADS logic to PADS Layout)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top