Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Adding real time as an input

Status
Not open for further replies.

jjzai123

Junior Member level 3
Joined
May 12, 2017
Messages
26
Helped
0
Reputation
0
Reaction score
1
Trophy points
1
Activity points
191
Hi guys, I have a project right now is about building a solar tracker by using Simulink. I am doing the sun position modeling in Simulink. Since the sun position calculation involve time as an input, I will need to give a time for the model to run. For example, I set my starting time to 9am and 5pm as and end time, the model will be calculate every 15 minutes. But how can I do that?
 

What about start by doing an algorithm in pseudocode with the main routines that you consider to run? It would be expected to implement this function separately from the testbench, so that the result could be evaluated for different scenarios.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top