Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Neoway M590E - error after power On.

Status
Not open for further replies.

jiijjuu

Newbie level 1
Joined
May 4, 2018
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
According to Neoway M590E hardware design manual, for proper operation of the sim, pins 11 & 14 (SIMIO, SIMVCC) of modem should be having high-level signals.

But in my case, both pins are zero volts after power on with 3.97 volt supply. Pull-up resistance used between both pins is 4.7k ohms.

Your expert help on this will be appreciated.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top