Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Impedance measurement in ADS

Status
Not open for further replies.
M

mickey123

Member level 5
Joined
Mar 23, 2015
Messages
93
Helped
0
Reputation
0
Reaction score
1
Trophy points
6
Activity points
666
Dear all,

Which parameter and using what steps should I simulate and measure the input impedance across a rectifier circuit in ADS?

Thanks in advance :)
 

I think small signal input impedance is useless in such case.
You can find the HB steady state large signal input impedance by dividing complex voltage to complex current at input node.Complex current can be measured with I_Probe element.
Voltage should be defined as a net.
 

Thank you for the reply :)
I plotted the Smith Chart of Vin . Can you please look into the figure and tell me what is the complex voltage?

smith.png
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top