Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

TLC5940 based current source - suggestions sought

Status
Not open for further replies.
B

boylesg

Advanced Member level 4
Joined
Jul 15, 2012
Messages
1,023
Helped
5
Reputation
10
Reaction score
6
Trophy points
1,318
Location
Epping, Victoria, Australia
Activity points
11,697
Fairly easy if the LED supply voltage is 5V - same as the TLC5490 supply. Just use a PNP transistor.

But it doesn't work if 12V is on the emitter of the PNP transistor - the PNP will always be turned on since the 12V on the emitter is always greater than the max 5V that can be applied to the base through the TLC5490 channel?
 

Not clear what you want to achieve with transistor.

the PNP will always be turned on since the 12V on the emitter is always greater than the max 5V that can be applied to the base through the TLC5490 channel?
Click to expand...

??? TLC5940 output channel compliance is 18V rather than 5V.
 

FvM said:
Not clear what you want to achieve with transistor.



??? TLC5940 output channel compliance is 18V rather than 5V.
Click to expand...

VO Output voltage range
V(OUT0) to V(OUT15) –0.3V to 18V
EEPROM program range V(VPRG) –0.3V to 24V

According to the datasheet you can use 0.3V to 18V on the output channels, so 5V through the LEDs should be fine.


VIH High-level input voltage 0.8 VCC VCC V

Also according to the data sheet HIGH on an input channel can only ever be Vcc=5V, which is fine except when you want to make the TLC5940 a LED current source via PNP transistors with a voltage greater than Vcc=5V.

Would be a lot more flexible if they made VIH equal to the LED supply voltage.
 

Sorry, I don't understand what you want to achieve.

Why "make the TLC5940 a LED current source via PNP transistors"?
Why drive more than 5V to any of the TLC5940 digital inputs?

Can you sketch a schematic of the intended configuration?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top