Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Would smd resistor on ridge waveguide (or rgw waveguide) act as series resistor?

Status
Not open for further replies.
Georgy.Moshkin

Georgy.Moshkin

Full Member level 5
Joined
Oct 9, 2017
Messages
270
Helped
44
Reputation
88
Reaction score
39
Trophy points
28
Activity points
2,507
Fields around ridge waveguide are very similar to microstrip line with air dielectric, especially for RGW waveguides.
Unfortunately cutting ridge for placing smd component may form (?) groove gap waveguide.
Is it possible to integrate SMD components directly to the ridge gap waveguides (RGWs)?
I have an idea of cutting waveguide walls below SMD component, or use bed of nails under smd component.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top