Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Observing intermittent outputs in DSP

Status
Not open for further replies.

garimella

Full Member level 5
Joined
Aug 25, 2011
Messages
260
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
3,276
I am new to DSP. I have done some of the simulations in matlab and I was clearly able to observe all the intermittent waveforms. I would like to do the same thing using a DSPIC micro-controller. Is there any software to observe the results that run live on the micro controllers? (basically looking for an embedded scope)
 

If the device you are using has an on-board DAC, use that.
Or use an external SPI DAC
 

Do you I need to select multichannel dad to see multiple outputs at a time.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top