Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Step by step design of inductor and transmission line

Status
Not open for further replies.
C

circuitking

Full Member level 5
Joined
Jan 8, 2018
Messages
291
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Activity points
2,503
Hi,I am new to the circuit designing.I would like to know how to design an inductor and transmission line in ADS/SONNET/Cadence.What are the steps involved in the procedure.I heard that one has to carry out EM simulation to find out the parasitics impact after the layouting the indcutor/transmission line.
Could someone provide the whole procedure and relevant information on books to refer and best simulator to use.Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top