Hello all,

I'm trying to help out with the following https://forums.xilinx.com/xlnx/board...ssage.id=14939

I can see the zynq config control, however since i don't have means to probe, I don't know if SYSCTLR_SDIO_MUX_SEL/OE is ever set, such that sd micro is connected to the fgpa. From what I can see it looks like it's just asking to initiated a boot from sd-micro, rather than use it as a data storage device.

Please could someone put my mind at rest. Does the user need to configure the uart - zynq each time, or can it be permenantly configure to link fpga to sd-micro. I come here because xilinx have been completely quite on this front.