Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Question about PCB glue? possible usage without reflow oven

Status
Not open for further replies.
Re: question about pcb glue ? possible usage without reflow oven

As I see on their page, this is an epoxy based glue and will not melt under heat. Normally the component floats on the solder during soldering and positions itself (surface tension forces from the molten solder) but if the glue is cured before that this will not happen. I guess this is suitable for manual placement and soldering.
 

Re: question about pcb glue ? possible usage without reflow oven

These are one-part thermo-setting epoxy adhesive with curing temperature of 130 deg C for 5 minuts. It should not cure in normal temperature. Re flow or Oven curing preferring
 

Re: question about pcb glue ? possible usage without reflow oven

so I guess, I'd hate to use krazy glue instead :)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top