Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

simulation in vivado vs ISIM(in Xilinx ISE)

Status
Not open for further replies.

rafimiet

Member level 5
Joined
May 21, 2015
Messages
94
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
2,364
I have been using Xilinx ISE and ISIM for quite a few years now. But now, due to some reasons, I have to switch to Vivado. I can not find the simulation setup in vivado the same way as ISIM. Also I am not much familiar with Vivado. Firstly, ISE would auto generate the test bench, which needed small modifications to serve your purpose. Secondly there were manual simulations possible in ISIM. The test vectors were generated using the command PUT (for example: put a 10101010). Can I have similar kind of simulations in Vivado? Or has it become simpler in Vivado in any respect?
 

I can not find the simulation setup in vivado the same way as ISIM.

Left-hand corner, Project Manager --> Settings will open up the Settings window. From there just select Simulation and you will get its options.

I think you should read the latest version of the ug910-vivado-getting-started.pdf and play around with the tool for sometime.

Vivado is much better, have fun!
 

Left-hand corner, Project Manager --> Settings will open up the Settings window. From there just select Simulation and you will get its options.
But ISIM is not there. Is there a way to enter manual simulations?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top