prabha1x1
Newbie level 1
Hello,
While import the nets from schematic all the components are correctly imported and nets also imported properly. But ratsnest does not visible in pcb editor. I done all the changes like command widow >>view>>connections >> show all nets. Layer colours> show from and Tos enabled. But it does not show the ratsnest. If I route the track means I can able to route the traces . Means everything is ok execpt the visibility of ratsnest. I think may be due to some settings issue in the pcb editor in altium. please anyone can give me the solution for this.
While import the nets from schematic all the components are correctly imported and nets also imported properly. But ratsnest does not visible in pcb editor. I done all the changes like command widow >>view>>connections >> show all nets. Layer colours> show from and Tos enabled. But it does not show the ratsnest. If I route the track means I can able to route the traces . Means everything is ok execpt the visibility of ratsnest. I think may be due to some settings issue in the pcb editor in altium. please anyone can give me the solution for this.
