Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[H/F/S/S]Help me in this structure, port poblems...

Status
Not open for further replies.
S

seira

Newbie level 4
Joined
Apr 15, 2005
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,347
This is my model structure with port problems
Help me.. How can I assign port to this structure
This is LTCC digit cap model..

Help me~~~plz.
 

hi
from where do you feed in physical structure? in tutorials, there are examples similar to your problem.
 

haydar said:
hi
from where do you feed in physical structure? in tutorials, there are examples similar to your problem.
Click to expand...
This simulation model is testing model for my LTCC coupon structure, and I have problem with constructing this simulation model in port defining.
I'm trying to insert both Wave port and Lumped port excitation, but error occurs or it result in 'inductor characteristics' even though it is capacitor.
I don't know where is the tutorial example for this problem, plz give me more information about tutorial examples or other sources.

Thank you for your replying.
 

write your e-mail address. i will send tutorials i have
 

pls, upload your tutorials, i am very interested in that model, thk you, regards Edmund
 

haydar said:
write your e-mail address. i will send tutorials i have
Click to expand...
My e-mail address is

"seira325@msn.com"

Plz, send the turorial files to this e-mail address.
Thank you^^
 

haydar said:
hi
from where do you feed in physical structure? in tutorials, there are examples similar to your problem.
Click to expand...

my gmail is "ahn.minsu@gmail.com"

sorry to bother you

i'm waiting for your help.
 

Hello;

The port is inside the structure; as i have understood, you have to use lumped port, but not wave port, to excite the 3D model.

Added after 58 minutes:

Hi, seira;

Have you ever checked the setting of the material "segment 6" as the dielectric material?? I found that you set it conditivity is the same as that of silver! Therefore, if the set is not correct, your 3D model will be a bulky conductor which will be like an inductor. for your information.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top