dann11
Full Member level 3
Hi everyone! I am trying to test Texas instruments EVM(TMDSHV1PHINVKIT), it provided different sets of test builds at its user manual. I am still at the 1st build and still cant proceed. I was able to load the program and have injected a 380Vdc at its input terminal. I also did use it GUI to control the board but it continuously senses a fault, "DC under voltage".
The 380Vdc input is the voltage requirements of the system, as I have checked it at its program and user manual.
Has anybody tried the same test? Do you have any idea guys on what might I have missed? Or what might I have done wrong with the Build 1 set up.
The 380Vdc input is the voltage requirements of the system, as I have checked it at its program and user manual.
Has anybody tried the same test? Do you have any idea guys on what might I have missed? Or what might I have done wrong with the Build 1 set up.