Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

short circuit protection in supply

Status
Not open for further replies.
E

electonicsproject

Banned
Joined
May 20, 2017
Messages
54
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
0
I have used MCB rated at 220V 6Amp
when the current reaches more than 6amp at short circuit the mcb trip switch off.
but i want to know how to design a short circuit of voltage at few mili amps it should off the power supply how to achieve this?
 

Sounds like a GFI fault switch. They trip with a small unbalance current.

You mentioned shorted voltage. That would also be a high current,so you can use a current sensor to trigger a relay.
.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top