Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

using Moc 3063 and Triac BT139 for DC Switches ???

Status
Not open for further replies.
M

m3hdi.mhmvd

Newbie level 2
Joined
Apr 9, 2017
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
13
Hi guys ,
Can I use triac BT139 and moc 3063 for switching DC power supply ??? and if the Snubber circuit has been used , does it make a problem for Dc loads ???
 

A triac or SCR can't switch DC loads, because it only turns off if the current falls below holding threshold before. The same with MOC30xx opto triacs. In addition, MOC3063 will neither turn on due to zero crossing logic.

Pulsating DC (unfiltered rectified AC) with resistive or capacitive load can however work.
 

but when I use DC for Moc3063 and triac it works and turned it off or on :shock:
 

Hi,

Then show us your schematic...

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top