Nhera
Member level 1
I want to use a wire mesh to replace a metal sheet.
CST Gives the error "There are thin wires with distance less than 1e-4 which are not properly connected. Consider to increase the value specified under mesh properties -> specials -> geometry accuracy"
I do not know how to "connect" these wires, my model looks like this
Any advice?
CST Gives the error "There are thin wires with distance less than 1e-4 which are not properly connected. Consider to increase the value specified under mesh properties -> specials -> geometry accuracy"
I do not know how to "connect" these wires, my model looks like this
Any advice?