Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microstrip antenna array feed network design

Status
Not open for further replies.
The firtst question is ... for what frequency? The patch antenna is on tje same PCB than forming network?

But for higth frequency antennas a good choice use to be cuclad 2.45 or any similar material for oter manufacturer

TaPa
 

Hi Tapa,

I think I was not clear about my question. The substrate is a semiconductor substrate with some processing to offset the high epsilonr. My question was "where can I find design steps for designing the feed network". Sorry for the confusion.

-svarun
 

you can try microstrip antenna design handbook by ramesh garg
 

I think U can find useful methods in "Microstrip Antennas: The Analysis and Design of Microstrip Antennas and Arrays" by David. M. Pozar
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top