+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Advanced Member level 2
    Points: 3,560, Level: 14
    Achievements:
    7 years registered

    Join Date
    Aug 2010
    Location
    Iberian Peninsula
    Posts
    577
    Helped
    7 / 7
    Points
    3,560
    Level
    14

    Noise Simulation using cadence

    Hi everyone,

    I am designing an offset cancellation circuit and I want to do a noise simulation. My goal is to do the simulation using the circuit without the offset cancellation technique and then using the same topology using the offset cancellation technique and compare both noises.

    I have tried the noise analysis, but I don't know if this analysis takes into account the switching behaviour/nature of the cancellation circuit since the noise analysis is just a simple frequency sweep across the desired frequency range.

    Does anyone knows how to do it?

    Regards.

    •   AltAdvertisement

        
       

  2. #2
    Full Member level 3
    Points: 2,888, Level: 12
    Achievements:
    7 years registered

    Join Date
    Jul 2007
    Posts
    151
    Helped
    14 / 14
    Points
    2,888
    Level
    12

    Re: Noise Simulation using cadence

    Since you are saying its a switching technique based offset cancellation. Your should be using periodic steady state methods. PSS/PNOISE will help you,



--[[ ]]--