Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

input to serial to parallel and to parallel to serial what will be the output?

Status
Not open for further replies.
S

sandy3129

Member level 3
Joined
Nov 7, 2014
Messages
56
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
445
input to serial to parallel and to parallel to serial what will be the output ?

if I give a binary input to serial to parallel block and then to a parallel to serial block should my output be the same ???

if same then why are we doing it , better to delay rather than adding serial to parallel block and parallel to serial block know ???
 
Last edited:

Re: input to serial to parallel and to parallel to serial what will be the output ?

Such a mechanism is used by inter-chip communication protocols. Because the no. of ports/pins used are drastically reduced. Other than very specific reasons, I don't think
binary input to serial to parallel block and then to a parallel to serial block
Click to expand...
is not used for inter-chip communications.
 

Re: input to serial to parallel and to parallel to serial what will be the output ?

in hardware implementation of instantaneous frequency measurement we do it . thanks for the answer.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top