Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST cannot export S-parameters data

Status
Not open for further replies.
F

flyingoven

Newbie level 6
Joined
Aug 6, 2016
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
108
Hi! Everyone!

After I simulated, I want to remove higher mode from ports by Exclude port mode in Post Processing,then exported S parameters. But CST appeared message:

All calculated S-Parameters are set to be excluded from post processing.

Error while running S-parameter post processing.

Error in TOUCHSTONE export initialization. No S-Parameter data found.
Click to expand...

Export S parameters data failed.

My model is APC-7 coax air transmission line, and the middle part is Teflon.

What is the problem? Thanks.

**broken link removed**
 

I have following questions to understand your problem better
1. Which solver of CST you are using?
2.What S parameters data will be left when you say exclude port mode as per my understanding S parameters are calculated at ports. So when you exclude ports nothing is left to be exported so it is the error in post processing
 

I choice Frequency domain solver as solver.
Oh, I see! However I want to remove higher mode from ports so that S-parameters results don't include effect from my 2-ports measurement.
Is there other method to remove effects caused by ports?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top