snipex
Junior Member level 3
Hi,
I'm currently working on a FRDM-KEAZ128 board. The plan is to then use this mcu on a custom PCB and program it.
I looked for some programmers and there seems to be only two (Cyclone MAX and Flasher ARM). Both are extremely expensive.
Then I found this debugger but I don't know if I can program with it:
https://si.farnell.com/nxp/u-multilink/dev-interface-mcu-development/dp/2315740
I also found another way but this is not ideal:
https://mcuoneclipse.com/2013/04/21/using-the-freedom-board-as-jtag-programmer/
Does anybody has any experience with this?
It would be great if the programmer would be below 200€.
I'm currently working on a FRDM-KEAZ128 board. The plan is to then use this mcu on a custom PCB and program it.
I looked for some programmers and there seems to be only two (Cyclone MAX and Flasher ARM). Both are extremely expensive.
Then I found this debugger but I don't know if I can program with it:
https://si.farnell.com/nxp/u-multilink/dev-interface-mcu-development/dp/2315740
I also found another way but this is not ideal:
https://mcuoneclipse.com/2013/04/21/using-the-freedom-board-as-jtag-programmer/
Does anybody has any experience with this?
It would be great if the programmer would be below 200€.