ssc953
Newbie level 1
Hello
I am trying to connect DRF1276DM (UART based radio modem) to the PC.
For this purpose I have purchased CP2102 based USB to UART converter board (CP2102 USB to TTL USB UART serial port converter module +ARDUINO PROGRAMMER on ebay).
I have successfully installed the USB drivers and the USB-UART board is being recognized by the PC.
Following connections have been used:
Radio Tx -> Converter Rx
Radio Rx -> Converter Tx
Radio Vcc -> Converter 5V
Radio GND -> Converter GND
However, I am not able to communicate with the modem using serial port tool. Even the LED which flickers for some few seconds when connected to RPi shows nothing.
What could be going wrong here?
Thanks in advance.
I am trying to connect DRF1276DM (UART based radio modem) to the PC.
For this purpose I have purchased CP2102 based USB to UART converter board (CP2102 USB to TTL USB UART serial port converter module +ARDUINO PROGRAMMER on ebay).
I have successfully installed the USB drivers and the USB-UART board is being recognized by the PC.
Following connections have been used:
Radio Tx -> Converter Rx
Radio Rx -> Converter Tx
Radio Vcc -> Converter 5V
Radio GND -> Converter GND
However, I am not able to communicate with the modem using serial port tool. Even the LED which flickers for some few seconds when connected to RPi shows nothing.
What could be going wrong here?
Thanks in advance.