Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
To get max power out of the device, you will have to excite it with an AC wave of 140V peak to peak (see post #2) at 40kHz. The output power has not been specified. It may be wise to reduce the max voltage by about 20% to leave some headroom. That will reduce the output power but that will depend on the nature of the coupling.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.