Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] duplicate part reference in proteus

Status
Not open for further replies.
Y

younes_ysf

Newbie level 3
Joined
Sep 7, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Iran
Activity points
1,297
hi all
i have problem in simulating a schematic. i have two netlist compiler error.
Duplicate part reference: X00000004#1 [X00000004#1].
Simulation FAILED due to netlist compiler error(s).
Untitled.png
it seems that there is duplicate part reference, but which one?
the schematic file is attachad
tnx for your help in advanced
 

Attachments

  • SHEMATIC.rar
    28.9 KB · Views: 535
Last edited:

There is probably an error in the way the Input Adapter component was created. If you replace it with a 3 pin connector the error goes away. Since the part is marked as not to be included in the PCB, just replace it with something else. If you want to include it in the PCB later on, keep the 3 pin connector and tie it to the PCB footprint for the actual connector.
 
i tried to make new one by myself:-D
thank you all
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top