Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

28byj-48 stepper motor frequency

Status
Not open for further replies.

alphonsjp

Newbie level 6
Joined
Oct 29, 2013
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
87
HI .
In the datasheet of 28BYJ-48 stepper motor frequency is given as 100 Hz. What is the significance of this frequency. ?

Regards
ALPHON
 

Perhaps it is meant as the maximum frequency with the specified load the motor will *not* miss a step. It may run (it will certainly) faster but it will miss some steps. Basically they run-stop-run (it may not stop fully but it can if needed) and the rotor inertia is the problem.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top