Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem in programming VIRTEX-II pro development board using JTAG

Status
Not open for further replies.
S

shobhitsriv

Newbie level 4
Joined
Jun 3, 2016
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
53
I had been using a VIRTEX_II pro development board and it had been working fine , but recently I had to change it (but still its another VIRTEX-II pro development board).

Now, when I try to program it using JTAG then it shows the following error

Cable connection failed.
PROGRESS_END - End Operation.
Elapsed time = 7 sec.
Cable autodetection failed.
WARNING:iMPACT:923 - Can not find cable, check cable setup!

Can anyone help me out here?
 

This type of error usually means things like:

  • No cable attached (xilinx programming pod, or Digilent solution on the board)
  • Driver not installed or is the wrong version for the cable/embedded JTAG programming interface.
 

Try uninstalling and then re-installing the driver, in many cases it works!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top