Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PrimeTime: Average vs Peak power differ at Total power

Status
Not open for further replies.
K

kalar

Newbie level 5
Joined
Nov 24, 2014
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
75
Hi,

I know the difference of average and peak power, however the total power is different between these two analysis of my design (using the same testbench-full annotation). Does this make sense? If yes, why? If not, where should I place my effort to debug this issue?


my best,
Harry
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top