Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

patch antenna fabrication

Status
Not open for further replies.
M

math_daoud

Newbie level 6
Joined
May 20, 2016
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
78
Dear All,

I have simulated a patch antenna using CST 2014 the result gave me very good BW and radiation pattern, from here i am new and i have no idea how to start the fabrication, my question is how to layout the simulted patch antenna?


Thank you
 

you can generate gerber in CST.

modeling --> import/export -->export 2D files --> gerber (single layer).
 

pragash said:
you can generate gerber in CST.

modeling --> import/export -->export 2D files --> gerber (single layer).
Click to expand...

Then, you can use CAM350, import gerber file to CAM350, export to CAM file and manufacture
 

Just you can Move the ground and top layer to the same layer and also make it 2D. 2D means that height of copper should be zero, then try normal procedure, i think it will help you.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top