Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

delta connect load voltage at open side

Status
Not open for further replies.
R

raman00084

Full Member level 6
Joined
Nov 29, 2010
Messages
362
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,006
https://obrazki.elektroda.pl/8179396100_1460918152.jpg

in the above circuit digram of delta load what is the voltage present on open end side with respect to netral



regards
Delta.jpg
 

We assume R-Phase and Y-Phase are measured relative to the Neutral ground icon.
The influence of the resistor network is symmetrical.
Therefore V is always the average of R-Phase and Y-Phase.
Perhaps the answer requires more thought than the above, so don't take my reply as the only answer.
 

Well the attached ltspice simulation shows that its 116VRMS.
 

Attachments

  • Three phase_forum.txt
    1,010 bytes · Views: 56

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top