Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Zolertia/Contiki sensor data upload to things.ubidots.com

Status
Not open for further replies.

usmanOnboard

Newbie level 1
Joined
Apr 16, 2016
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
I have two z1 motes and wants to upload temperature data to cloud using website things.ubidots.com


I followed all the steps that described in given link:

**broken link removed**

Border Router terminal log:
************SLIP started on ``/dev/ttyUSB1''
opened tun device ``/dev/tun08''
ifconfig tun08 inet `hostname` up
ifconfig tun08 add 2001:582:37:19d2::/64
ifconfig tun08 add fe80::582:37:19d2:0/64
ifconfig tun08
tun08 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:127.0.1.1 P-t-P:127.0.1.1 Mask:255.255.255.255
inet6 addr: 2001:582:37:19d2::/64 Scope:Global
inet6 addr: fe80::582:37:19d2::0/64 Scope:Link
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:500
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)**

*** Address:2001:582:37:19d2:: => 2001:0582:0037:19d2
Got configuration message of type P
Setting prefix 2001:582:37:19d2::
Server IPv6 addresses:
2001:582:37:19d2:c30c::1e6
fe80::c30c:0:0:1e6**

Added Ubidots variable Ids in project-conf.h & one in Makefile as well

running Ubidots-demo.c on another z1 mote here are logs:

Ubidots client: STATE_RESOLVING (3)
Ubidots client: STATE_RESOLVING (3) Ubidots client: STATE_RESOLVING (3) Ubidots client: STATE_RESOLVING (3)
Ubidots client: STATE_RESOLVING (4)
Ubidots client: STATE_RESOLVING (4)

If some one else did this successfully or faced same errors
Please help me here to figure out this stuff, or tell me where I m doing wrong.

This is really really important for me to solve.
Any help will be much appreciated.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top