+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Full Member level 1
    Points: 1,613, Level: 9
    jovin555's Avatar
    Join Date
    May 2012
    Posts
    115
    Helped
    0 / 0
    Points
    1,613
    Level
    9

    STM32F103VCT6 interfacing with WF70Q

    I would like to know whether it is possible to interface stm32f103vct6 with winstar display WF70Q using FSMC bus?
    I would like to print moving images on the display.the datasheet for both are attached.

    Also if it is possible to interface,which fsmc topology do we need to use?is it asynchronous non-multiplexed NOR write method?

    What is the main difference between asynchronus multiplexed and non-multiplexed fsmc methods?

    •   AltAdvertisment

        
       

  2. #2
    Advanced Member level 5
    Points: 8,573, Level: 22
    Easyrider83's Avatar
    Join Date
    Oct 2011
    Location
    Tallinn, Estonia
    Posts
    1,525
    Helped
    348 / 348
    Points
    8,573
    Level
    22

    Re: STM32F103VCT6 interfacing with WF70Q

    Sure, it is possible. It uses SSD1963 display controller.
    Love me or hate me. All infractions will be ignored.



    •   AltAdvertisment

        
       

  3. #3
    Full Member level 1
    Points: 1,613, Level: 9
    jovin555's Avatar
    Join Date
    May 2012
    Posts
    115
    Helped
    0 / 0
    Points
    1,613
    Level
    9

    Re: STM32F103VCT6 interfacing with WF70Q

    So if we are using the fsmc bus, is there any clock signal involved during communication?Since the display datasheet is talking about a system clock,so how should we give the clock needed for the display?
    Also in the stm32f10xC datasheet,on page 68,there is a table showing the write timings.There what should be the minimum value of tHCLK when using the fsmc bus for disply?



--[[ ]]--