flote21
Advanced Member level 1
Hello guys,
I am planning to use two units of this Octal buffer 3-state IC for my next design: 74HC367.
I want to use two 74HC467 in parallel interconnecting their outputs (Because they are 3-state) and making a control of the ouput enable pins throught an FPGA.
My question is if I need to place pull-up/down for every output of the buffer or with the basic wire interconnection is enough?
Thanks in advance.
I am planning to use two units of this Octal buffer 3-state IC for my next design: 74HC367.
I want to use two 74HC467 in parallel interconnecting their outputs (Because they are 3-state) and making a control of the ouput enable pins throught an FPGA.
My question is if I need to place pull-up/down for every output of the buffer or with the basic wire interconnection is enough?
Thanks in advance.