+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Newbie level 1
    Points: 16, Level: 1

    Join Date
    Jan 2016
    Posts
    1
    Helped
    0 / 0
    Points
    16
    Level
    1

    Eagle Clearance error

    I am using an STM32 microcontroller component in my design and getting lots of clearance errors. I am using default eagle DRC file and haven't modified anything in the library.
    The library, schematic and brd file is attached. Thanks in advance.
    Test_board.7z

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 77,854, Level: 68
    Achievements:
    7 years registered
    Awards:
    Most Frequent Poster 3rd Helpful Member

    Join Date
    Apr 2014
    Posts
    15,786
    Helped
    3592 / 3592
    Points
    77,854
    Level
    68

    Re: Eagle Clearance error

    Hi,

    your spacing between the pads is about 0.2mm. There is nothing obviously wrong with the package.

    I assume the DRC setup says it needs more than 0.2mm spacing.
    Usually the PCB manufacturers have no problem down to 0.15mm.
    So i recommend to adjust the DRC setup.

    Go to the PCB manufacturer´s website and look for design rules. Find the values and edit/create a "Manufacturer_name.DRC" file.

    Klaus



--[[ ]]--