Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Potentiometer standard values?

Status
Not open for further replies.
M

muhammad_saad

Newbie level 1
Joined
Mar 15, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
11
I was looking for a potentiometer of 2.7k but couldn't find one in the market although we do have a standard resister value of 2.7k.
I just want to make sure whether the potentiometers have same standard values as the resistors?
Moreover, i couldn't find the table of standard potentiometer values like we have for standard resistor values. So, can anyone plz provide me this table.
I shall be thankful
 

These are basically E3 series. I have not seen 2.5 or 25K pots. Some come in log taper but muliturn pots are always linear. Pots for volume controls are always log taper, correct (I am not quite sure)
 

Hi,

There are manufacturers of potentiometers.
They provide datasheets.
It's the most simple and reliable place to answer your question.

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top