Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Some common Analog terms

Status
Not open for further replies.

shemo

Advanced Member level 4
Joined
Apr 26, 2002
Messages
105
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
709
1)Why db ranging mostly from 0 to negative? peak at 0 level and as it decreases it goes negative? why no positive?

2)noise floor in -155dBm/Hz what's dBm? why its over frequency?


3)why resisitity express in ohm-cm? why cm which is length? not not ohm-area?

4)what 's a epi versus non epi wafer?
 

1) dB can be positive or negative. It's often negative for noise levels and positive for gain or signal-to-noise ratio.

2) dBm is the signal power relative to 1 mW. Thus -10dBm is 10dB below 1mW or 0.1mW.
The noise is given per Hz (a 1 Hz bandwidth) so you can calculate the total noise in a given bandwidth because the total noise is proportional to the square-root of the bandwidth.

3) Resistivity is given per distance for a (theoretical) infinite area of the test material. This means the measured resistance is simply proportional to the distance between the test probes (in this case in cm) times the resistivity.

4) A epi wafer has an epitaxial layer, whereas obviously a non-epi wafer doesn't.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top