Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to generate a signal with phase noise in a power source in Agilent ADS

Status
Not open for further replies.
T

tanjil

Newbie level 2
Joined
Sep 19, 2012
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,300
Hello Designers
I am simulating a full RF Transmission system in 60 GHz. I have a LO with frequency 20 GHz. I want my LO source to have phase noise (e.g. -100 dBc/Hz at 100k offset from 20GHz). I am using the source P1_tone (Agilent ADS). But I do not see any phase noise in my simulation. I am using Harmonic Balance (HB) simulation. All I need is to see the phase noise. So I am looking for a signal of 20 GHz with some phase noise. Can someone help me please!!

P.S. I have already done the steps in Help file to turn on the phase noise for this source. However, I cannot see the noise in HB simulation

BR
Tanjil
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top