Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

skill- layer replace in a bounding box

Status
Not open for further replies.

Chandan_333

Newbie level 5
Joined
Jun 30, 2012
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,327
How can I replace a layer with other one in a defined bounding box area? please share...
 

Do it manually, then check the logFile, it contains the corresponding skill code.
 

thanks! But how to do this please explain...as I am a beginner in skill...
 

When you've found the skill code, simply put this line(s) of code into the CIW to run it again. If you need it often, put it into a file and load this fileName.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top