+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Member level 5
    Points: 1,947, Level: 10
    Achievements:
    7 years registered

    Join Date
    Apr 2011
    Posts
    84
    Helped
    0 / 0
    Points
    1,947
    Level
    10

    FLyback Circuit Compensation design UC3845

    Hello,

    can someone help me how to design a compensation network for an optocoupler included flyback converter operating in DCM mode? say unniversal input to 12V /2A output.
    Im using IC UC3845. Any step by step design procedure available?

    Thanks

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 52,908, Level: 56

    Join Date
    Apr 2011
    Location
    Minneapolis, Minnesota, USA
    Posts
    12,946
    Helped
    2580 / 2580
    Points
    52,908
    Level
    56

    Re: FLyback Circuit Compensation design UC3845

    As a general concept, you want to configure the internal phototransistor to respond to the internal led, so that it delivers the correct volt level to the feedback pin.

    You must create the proper amount of current going through the led. If output voltage changes, then it must cause led brightness to change.

    In regard to the phototransistor, you install a resistance on its collector leg, which creates an output voltage that is usable by your control circuit. This must go up or down with led brightness.



    •   AltAdvertisement

        
       

  3. #3
    Advanced Member level 5
    Points: 32,956, Level: 44
    Achievements:
    7 years registered

    Join Date
    Sep 2008
    Location
    cambridge
    Posts
    6,857
    Helped
    498 / 498
    Points
    32,956
    Level
    44

    Re: FLyback Circuit Compensation design UC3845

    Only Basso book tell you this. Christophe Basso. I only attach some, you need to buy this book



--[[ ]]--