Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[Moved]: Question about Components in Cadence

Status
Not open for further replies.

Shady Ahmed

Member level 5
Joined
Jan 26, 2013
Messages
86
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
2,042
I have a question in Cadence,
say for example that i created a component (op amps ) and i intend to use that component in another schematic, for instance : i'll place it 10 times, however i want to change a value of some parameters in that op amp for 1 op amp without affecting the other 9, is there another way to do so other than creating a separate symbol for each?
 

Re: Question about Components in Cadence

There are parameters called pPar which are exactly what you are after. But you will need to meddle with cdf and stuff. There are guides online that might be doing exactly what you're planning to do.
 
Re: Question about Components in Cadence

Thanks for the answer, I knew it had to be in cadence but needed a name for that feature, I'll look into it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top