Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[moved] Measure the voltage on each net in transistor level schematic using hspice

Status
Not open for further replies.
Q

question_answer

Newbie level 3
Joined
Jun 25, 2015
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
38
Hi all,
I want to set an initial condition for all nodes in a schematic. I know I can do .IC V(net#)=0V one by one. Is there any easier representation that I can give the initial condition to all nodes at once?

And also, if my schematic is huge, I only want to know the voltage values of partial nodes(eg. half of the schematic nodes). How can I do it? ps: use .print V(net#) to print the voltage value of each nodes.

Forget to tell, using hspice

Please help me with the questions, thank you!
 
Last edited by a moderator:

Measure the voltage on each net in transistor level schematic using hspice

Hi all,
I want to measure the voltages on each net/wire of a transistor level schematic using hspice. I have the problem on writing the spice netlist. The .print V(nodes) can only print the voltage on input and output. I am not able to write .print(net#), it says the net# can not be recognized as a node. ps: net# is the net/wire where I want to measure the voltage at.

pls help me on the problem, thank you:p
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top