truebs
Full Member level 5
Low RF signal on CRO ?
Hi,
i made an Oscillator and to check its functioning i connected it to an Oscilloscope.
I coudn't get a proper wave form.
The reason i thought was that CRO has an input impedance of 1 Mega Ohms.
And my oscillator gives an output of around 300 mv (and with modified design 3V)
Is this the reason ?
What else could be the reason ?
And what are the ways to overcome this ?
Thanks !
Hi,
i made an Oscillator and to check its functioning i connected it to an Oscilloscope.
I coudn't get a proper wave form.
The reason i thought was that CRO has an input impedance of 1 Mega Ohms.
And my oscillator gives an output of around 300 mv (and with modified design 3V)
Is this the reason ?
What else could be the reason ?
And what are the ways to overcome this ?
Thanks !