Ishaan Karnik
Member level 3
We are building an automation system where by sensor will be separated form indicators/totalizator by few meters. We have decided to use CAN bus for communication between sensor and indicators.
We are suppling 24V to the sensor module. I would like to know if it is possible to supply power over the same cable (multi-core cable) as CAN Bus (using different core) without causing problems to CAN network.
One totalizator will be connected to one sensor only. We are open to protocol change also provided cost benefits and decrease in complexity.
Can someone point out practical implications for the same and pitfalls that can/need to be avoided.
We are planning to use DB-9 Connector but this (connector) can be changed as the project is still in development state.
Kindly inform me can such routing of power rail (24VDC) along with RS-485 can cause problems.
We are suppling 24V to the sensor module. I would like to know if it is possible to supply power over the same cable (multi-core cable) as CAN Bus (using different core) without causing problems to CAN network.
One totalizator will be connected to one sensor only. We are open to protocol change also provided cost benefits and decrease in complexity.
Can someone point out practical implications for the same and pitfalls that can/need to be avoided.
We are planning to use DB-9 Connector but this (connector) can be changed as the project is still in development state.
Kindly inform me can such routing of power rail (24VDC) along with RS-485 can cause problems.