+ Post New Thread
Results 1 to 1 of 1
  1. #1
    Newbie level 1
    Points: 835, Level: 6

    Join Date
    Feb 2014
    Posts
    1
    Helped
    0 / 0
    Points
    835
    Level
    6

    Issue with power estimation with PrimeTime

    Hello,

    I am estimating the power consumed by my circuit post-synthesis and also post-layout using PrimeTime. I am facing a strange problem regarding the estimated power. The procedure that I follow is:

    1. Get VCD file form Modelsim. I use the command “vcd add –r /cpu_test/cpu_inst/*” and run for about sometime.

    2. Run the script in Primetime. The script that I use is:

    Code ActionScript - [expand]
    1
    2
    3
    4
    5
    6
    7
    8
    9
    10
    11
    12
    
    set power_enable_analysis true
    set power_analysis_mode time_based
    read_verilog ./netlists/cpu.v
    current_design cpu
    link_design
    create_clock –period 40name clk clk
    set_propagated_clock [all_clocks]
    read_vcd –strip_path cpu_test/cpu_inst ./projects/project1/dump.vcd
    read_sdf ./netlists/cpu.sdf
    check_power
    update_power
    report_power

    I get different power estimates for different duration of simulation on Modelsim for producing the VCD file. The figures varies from few microwatts to few kilowatts!!! Obviously this doesn’t make any sense. I observed that this difference is because of the power of 10 is different in each case. For e.g. once I get the power estimate as 1.771e-04, for another run I get as 0.0177 and yet another time I get 1.771e+3. This behaviour is same for both post-synthesis and post-layout simulations.

    I can’t figure out the mistake that I am making. Can anybody please help?

    Thanks in advance - Girish
    Last edited by BradtheRad; 10th June 2015 at 21:24. Reason: Added code formatting

    •   AltAdvertisment

        
       

--[[ ]]--