Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] verilog and system verilog for behavioral models

Status
Not open for further replies.

DharmaSlice

Member level 1
Joined
Jun 8, 2012
Messages
34
Helped
5
Reputation
10
Reaction score
3
Trophy points
1,288
Activity points
1,487
Hi,

I have a requirement to define an output with a more 'analog' feel then the straight forward digital definition that I currently have in place.

dac_out is defined as a digital output

This is simply 1 or 0 based on:

------

module DAC (IOUTN, IOUTP, VDDA1V8,, BIAS, CLK, DAC,
);

inout VDDA1V8;
input BIAS;
input CLK;
input [13:0] DAC;

output IOUTP, IOUTN;



assign IOUTP = (output_enable) ? (ioutp_sb > 16383) ? 1'b1 : 1'b0 : 1'bX;
assign IOUTN = (output_enable) ? (ioutn_sb < 18384) ? 1'b1 : 1'b0 : 1'bX;


------


IOUTP goes high if the signal ioutp_sb is above 16383


with the real (analog type signal) being defined as:


// channel 'real' DAC output
ioutp_real = (output_enable) ? ($itor(dac_in_1) / (2.0**15.0 - 2.0)) : 0.0;
ioutn_real = (output_enable) ? ((16383.0 - $itor(dac_in_1)) / (2.0**15.0 - 2.0)) : 0.0;



I simply want to map this real signal to my actual output (without breaking the fact that the output is a single wire and not a huge bus of signals)

Is this possible with system verilog ? How ?

Thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top