Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Display FPC connector

Status
Not open for further replies.
A

ArticCynda

Advanced Member level 1
Joined
May 8, 2013
Messages
439
Helped
82
Reputation
164
Reaction score
81
Trophy points
1,308
Activity points
4,238

Hi,

It seems like an 31 way 0.5 mm pitch FPC.

On farnell i find 4 pieces with that configuration.

Klaus
 
Thanks for your reaction Klaus! With these settings I also found 4 on Farnell, but they all look quite different. May I assume that the display can be mated with all 4? Or are there other parameters to consider?
 

Hi,

In farnell you find datasheets to each connector. Lucky you ther are only 4 hits.
Look for fpc thickness, fpc width and if you want the connectinn on top or bottom side of the connector.

Klaus
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top