Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Gain Horn for WR975 rectangular flange to a circle

Status
Not open for further replies.
R

Roy1986

Newbie level 1
Joined
Apr 22, 2015
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
7
I need to find a fabricator somewhere around the Washington DC area that can build a gain horn transitioning from a WR975 to a circle. The circle will be going into the oven. Would it be better to have the circle bigger than the WR975 or make it fit inside? I would like to lose as little power as possible. If anyone has a blueprint or an example of what it should look like that would help tremendously.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top