Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to find delay path using Tcl command?

Status
Not open for further replies.
M

msdarvishi

Full Member level 4
Joined
Jul 30, 2013
Messages
230
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Activity points
2,349
Hello everybody,
I have a design that I implemented it. After PAR process, the TRACE analysis lists some of the critical paths available in the design, but not all of them. I am wondering how can I find the path delay between two nets by scripting in Tcl command? what is the exact command that I must write?

Thanks,
 

I don't believe it is possible to do using a Tcl script. ISE has very limited Tcl support and most of that is relegated to setting up various properties for programs like trace.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top