Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

path tracing in Xilinx ISE

Status
Not open for further replies.

farzian

Newbie level 3
Joined
Jun 25, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
Hi
i want to extract paths in ISE, paths that start with FF and end with FF.
My question is: I should use timing analyzer in ISE or timing report in planahead?
Timing analyzer reports complete information about some paths and does not contain information about all of filtered paths. How can I extract information about all of my favorite paths using timing analayzer?
thanks
farzian
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top