yuhiub90
Member level 2
- Joined
- Aug 2, 2012
- Messages
- 52
- Helped
- 1
- Reputation
- 2
- Reaction score
- 1
- Trophy points
- 1,288
- Location
- Hanoi, Vietnam, Vietnam
- Activity points
- 1,618
guys, I have a problem when simulating my design in Synopsys VCS. The simulation went wrong with all register contains X when I simulate my design in command line mode. But it run normally in GUI mode (i.e, invoke vcs compile with -R -gui options).
So what's the different between 2 mode simulation (any implicit options in GUI mode)?
Here's my current vcs options in command line:
Thanks,
Huy Bui
So what's the different between 2 mode simulation (any implicit options in GUI mode)?
Here's my current vcs options in command line:
Code:
vcs +v2k +evalorder -R -sverilog -Mupdate
Thanks,
Huy Bui